2026-11-07 · 4 min read
How to Draw a Clearance Envelope for a Small Wheeled Robot
Sketch the space a robot occupies while turning, including protrusions and flexible parts, before setting up a supervised route test.
Trace the robot’s outer edges
With the robot stopped and made safe under your project procedure, sketch it from above. Mark the widest and longest points, including bumpers, cable guards and sensor brackets. The chassis dimensions alone can miss the part that will first meet a wall.
Draw the turn, not just the straight path
Make a paper outline at the same scale as your route sketch. Move it through several plausible turn positions and trace the corners. Mark this as an estimate: different wheel layouts and surfaces can change how a robot turns, and the sketch does not establish safe separation distances.
Record what changes the outline
Consider a payload, removable battery cover or flexible part that can move outside the outline. Give each tested configuration a name. If a bracket moves between runs, update the sketch rather than reusing results from the old setup.
Use a mock route before an obstacle
Try the paper outline through a fictional doorway, then around a right-angle turn. If the rear corner crosses the drawn wall, widen the approach or change the path in the sketch. Only proceed to a physical test using your approved staged procedure and supervision.
Does a paper pass prove the robot will fit?
No. It highlights where to measure and observe. Real stopping behaviour, wheel slip and controller response need separate checks. Use the RoboSkies guide for broader build preparation, and check exact specifications before sourcing parts.
Continue building
Follow the complete RoboSkies build journey from planning to a working robot.
Explore the build guideExplore the robot marketplace